5.1.2.6 X524 Electronics power supply
Table 5-6 X524 electronics power supply
Terminal Designation Technical data
+ Electronics power supply Voltage: 24 V DC (20.4 ... 28.8 V)
Current consumption: max. 0.6 A
(including DRIVE-CLiQ and control of
digital outputs)
Max. current via the jumper in the con‐
nector: 20 A (15 A according to UL/CSA)
+ Electronics power supply
M Electronics ground
M Electronics ground
Type: Screw terminal 2
The maximum cable length that can be connected is 30 m.
Note
The two "+" and "M" terminals are jumpered in the connector. This ensures that the supply
voltage is looped through.
The digital outputs are supplied via terminals X520, X521, and X522.
5.1.3 Meaning of the LEDs
Table 5-7 Meanings of the LEDs on the Terminal Module TM15
LED Color Status Description, cause Remedy
READY - Off The electronics power supply is missing or outside the per‐
missible tolerance range.
–
Green Continuous
light
The component is ready for operation. Cyclic DRIVE-CLiQ
communication is taking place.
–
Orange Continuous
light
DRIVE-CLiQ communication is being established. –
Red Continuous
light
This component has at least one fault.
Note:
The LED is activated regardless of whether the corresponding
messages have been reconfigured.
Remove and ac‐
knowledge the fault.
Green/re
d
Flashing
light 0.5 Hz
Firmware is being downloaded. –
Flashing
light 2 Hz
Firmware download has been completed. The system waits
for POWER ON.
Carry out a POWER
ON.
Green/
orange
or
Red/
orange
Flashing
light
Component recognition via LED is activated
1)
.
Note:
Both options depend on the LED status when component rec‐
ognition is activated.
–
1)
See List Manual for the parameter to activate the recognition of components via LED
Terminal Modules
5.1 Terminal Module TM15
Supplementary component descriptions
Manual, 06/2019 59
To Next Page
Loading...
