Siemens SINUMERIK 810D Programming Guide

2
12.98 Subprograms, Macros
2.5 Sub
p
ro
g
ram with
p
ro
g
ram re
p
etition
2
840D
NCU 571
840D
NCU 572
NCU 573
FM-NC 810D 840Di

Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA)
−
04.00 Edition
2-103
2.5 Subprogram with program repetition
Program repetition, P
If you want to execute a subprogram several times in
succession, you can program the required number
of program repetitions in the block in the
subprogram call under address P.
Example:
N40 BORDER P3
The subprogram Border must be executed three
times in succession.
Value range:
P: 1…9999
The following applies to every subprogram call:
123
Main program
N40 BORDER P3
Subprogram
The subprogram call must always be programmed in
a separate NC block.
Subprogram call with program repetition
and parameter transfer
Parameters are only transferred during the program
call or the first pass. The parameters remain
unchanged for the repetitions.
If you want to change the parameters in the program
repetitions you must define declarations in the
subprograms.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English