13
12.98 Additional Functions
13
ï›™
Siemens AG 2000. All rights reserved
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
13-427
Additional Functions
13.1 Axis functions AXNAME, SPI, ISAXIS ........................................................................ 13-428
13.2 Learn compensation characteristics: QECLRNON, QECLRNOF............................... 13-429
13.3 Synchronized spindle .................................................................................................. 13-431
13.4 EG: Electronic gear (SW 5 and higher) ...................................................................... 13-441
13.4.1 Define electronic gear: EGDEF ........................................................................... 13-441
13.4.2 Activate electronic gear ....................................................................................... 13-443
13.4.3 Deactivate electronic gear ................................................................................... 13-445
13.4.4 Delete definition of an electronic gear ................................................................. 13-446
13.4.5 Revolutional feedrate (G95)/electronic gear (SW 5.2) ........................................ 13-446
13.4.6 Response of EG at Power ON, RESET, mode change, block search ................ 13-447
13.4.7 The electronic gear's system variables................................................................ 13-447
13.5 Extended stopping and retract (as of SW 5)............................................................... 13-447
13.5.1 Drive-independent reactions................................................................................ 13-448
13.5.2 Possible trigger sources ...................................................................................... 13-449
13.5.3 Logic gating functions: Source/reaction operation............................................... 13-450
13.5.4 Activation ............................................................................................................. 13-450
13.5.5 Generator operation/DC link backup ................................................................... 13-451
13.5.6 Drive-independent stop........................................................................................ 13-451
13.5.7 Drive-independent retract .................................................................................... 13-452
13.5.8 Example: Using the drive-independent reaction.................................................. 13-453
13.6 Link communication (SW 5.2 and higher)................................................................... 13-454
13.7 Axis container (SW 5.2 and higher) ............................................................................ 13-457
13.8 Program execution time/Workpiece counter (as from SW 5.2).................................. 13-459
13.8.1 Program runtime.................................................................................................. 13-459
13.8.2 Workpiece counter .............................................................................................. 13-460
To Next Page
Loading...
Need help?
General
