Siemens SINUMERIK 810D - Page 494

15
Tables 12.98
15.1 List of instructions
15

Siemens AG 2000. All rights reserved
15-494
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide Advanced (PGA) – 04.00 Edition
G33 Thread interpolation with constant pitch 0.001, ...,
2000.00
mm/rev
Motion command G33 Z... K... SF=...
; cylinder thread
G33 X... I... SF=...
; face thread
G33 Z... X... K... SF=...
; taper thread
(path longer in
Z axis than in X
axis)
G33 Z... X... I... SF=...
; taper thread
(path longer in
X axis than in
Z axis)
m1
G34 Increase in thread pitch (progessive change) Motion command G34 Z... K... F
ZU
=... m 1
G35 Decrease in thread pitch (degressive change) Motion command G35 Z... K... F
AB
=... m 1
G40
1
Tool radius compensation OFF m7
G41 Tool radius compensation to left of contour m 7
G42 Tool radius compensation to right of contour m 7
G53 Suppression of current zero offset (non-modal) incl. programmed
offsets
s9
G54 1st settable zero offset m8
G55 2nd settable zero offset m8
G56 3rd settable zero offset m8
G57 4th settable zero offset m8
G58
G59
G60
1
Exact stop deceleration m10
G63 Tapping with compensating chuck G63 Z... G1 s 2
G64 Exact stop – contouring mode m10
G70 Dimension in inches m13
G71
1
Metric dimension m13
G74 Reference point approach G74 X... Z...; separate block s 2
G75 Fixed point approach Machine axes G75 FP=.. X1=... Z1=...;
separate block
s2
G90
1
Dimension setting, absolute G90 X... Y... Z...(...)
Y=AC(...) or
X=AC Z=AC(...)
m
s
14
G91 Incremental dimension setting G91 X... Y... Z... or
X=IC(...) Y=IC(...) Z=IC(...)
m
s
14
G94
1
Linear feed F in mm/min or inch/min and
°
/min
m15
G95 Revolutional feedrate F in mm/rev or inch/rev m 15
G96 Constant cutting speed ON G96 S... LIMS=... F... m 15