01.91 9 Examples
9.1.3 Description of the PLC program
Dynamic flags, softkey parameters
FB No. Dynamic flag Softk. param. Display Description
No.
FB 170 226.0 F100 61696 193 Buffer assignment
FB 171 226.1 F101 61697 193 Magazine assignment
FB 172 226.2 F102 61698 193 Tool selection according to T No.
FB 173 226.3 F103 61699 193 Loading/unloading mag./spindle
from preselection
FB 173 226.4 F104 61700 193 Loading/unloading mag./spindle
from preselection
FB 175 226.5 F105 61701 171 Display tool data from buffer
assignment
FB 176 226.6 F106 61702 171 Change buffer assignment, tool
buffer
FB 177 226.7 F107 61703 172 Display tool data from magazine
assignment
FB 178 228.0 F108 61704 172 Modify magazine assignment from
magazine assignment
FB 179 228.1 F109 61705 172 Tool selection according to cursor
pos. magazine assignment
FB 180 228.2 F10A 61706 177, Additional cutting edge from buffer
179 and magazine
FB 181 228.3 F10B 61707 186, Additional cutting edge from loading
187,
188,
192
FB 187 228.4 F10C 61708 176, Display next cutting edge
177,
178,
179
FB 188 228.5 F10D 61709 177, Reactivate
179
FB 189 228.6 F10E 61710 177, Delete last cutting edge
179
FB 190 228.7 F10F 61711 174 Selection of loading display tape
FB 165 230.0 F110 61712 196 Exchange list (package 2)
FB 165 230.1 F111 61713 196 Missing tools (package 2)
FB 165 230.2 F112 61714 196 Tool list (package 2)
FB 166 230.3 F113 61715 175 Signal: Load spindle
FB 167 230.4 F114 61716 175 Signal: Unload spindle
FB 169 230.5 F115 61717 179 Enable tool
230.6 F116 61718 184
185
230.7 F117 61719 185
FB 163 232.0 F118 61720 194 Display P memory
FB 187 232.1 F119 61721 197 Display next cutting edges
232.2 F11A 61722 Unassigned
232.3 F11B 61723 Unassigned
232.4 F11C 61724 Unassigned
232.5 F11D 61725 Unassigned
232.6 F11E 61726 Unassigned
232.7 F11F 61727 Unassigned
© Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1 9–45
SINUMERIK 840/880 (PJ)
To Next Page
Loading...
Need help?
General
