Siemens SINUMERIK 840 Planning Guide

9 Examples 11.92
9.1.3 Description of the PLC program
FB 182 234.0 F120 61728 174 Load
FB 183 234.1 F121 61729 174 Unload
FB 169 234.2 F122 61730 177 Release tool
FB 185 234.3 F123 61731 186, Acknowledge
187,
189
FB 186 234.4 F124 61732 186, Abort magazine/spindle
187,
189
FB 168 234.5 F125 61733 188, Acknowledge spindle
191,
192
FB 186 234.6 F126 61734 188, Abort magazine/spindle
191,
192
FB 191 234.7 F127 61735 190 Acknowledge tape, positive
FB 191 238.0 F128 61736 190 Acknowledge tape, negative
FB 192 238.1 F129 61737 190 Abort tape
238.2 F12A 61738 Unassigned
238.3 F12B 61739 Unassigned
FB 193 232.1 F11A 61722 194 Unload to NC program
FB 171 232.2 F11B 61723 194 Magazine assignment
1)
FB 193 232.5 F11D 61725 193 Unload to NC program
232.6 F11E 61726 Unload to NC program
232.7 F11F 61727 Unload to NC program
_______
1) Only applies to ”Unload to NC program" function on SINUMERIK 880/880 GA2
9–46 © Siemens AG 1991 All Rights Reserved 6FC5 197-0AA40-1BP1
SINUMERIK 840/880 (PJ)

Siemens SINUMERIK 840 Specifications

General

Control Type	CNC
Axes	Up to 31
Display	TFT color display
PLC	Integrated
HMI	SINUMERIK Operate
Communication Interfaces	Ethernet, PROFIBUS, PROFINET
Type	CNC system
Programming Languages	G-code
Max Number of Channels	10
Operating Temperature	0 to 45 °C
Relative Humidity	Up to 95% (non-condensing)
Protection Class	IP54 (front panel)