EasyManua.ls Logo

Siemens SITRANS SCM IQ - Page 16

Siemens SITRANS SCM IQ
70 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
NOTICE:
Changes or modi󹪝cations made to this equipment not expressly approved by (manufacturer
name) may void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o󹪜 and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit di󹪜erent from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING
Commissioning and operation with pending error
If an error message appears, correct operation in the process is no longer guaranteed.
Check the gravity of the error.
Correct the error.
If the error still exists:
Take the device out of operation.
Prevent renewed commissioning.
The same risk continues to apply when error messages are switched o󹪜 or disabled.
Safety notes
2.3Requirements according to 15.19. (FCC) / RSS-GEN
SITRANS CC220 and SITRANS MS200
16 Compact Operating Instructions, 10/2023 - DRAFT, A5E...-AA

Table of Contents

Other manuals for Siemens SITRANS SCM IQ

Related product manuals