3.1.6 Installing the top housing
Installing the top housing
1. Align the bottom of the top housing to the heatsink edge. Make sure the marked hooks
hooked the heatsink. Carefully insert the COM interface into the top housing.
2. Insert the two plastic clips of top housing into the clip holes on heatsink.
3. Press the top housing to x the clips.
Then install power plug and screws for COM interface.
Installing/mounting
3.1Installation instructions SITRANS CC220
SITRANS CC220 and SITRANS MS200
34 Compact Operating Instructions, 10/2023 - DRAFT, A5E...-AA
To Next Page
Loading...
