Siemens SITRANS SCM IQ - Mounting on DIN Rails

3.1.3.2 Mounting on DIN rails
Mounting
1. Place the device and rail clamp on the upper edge of the standard pro󹪝le rail at the position
shown and push the device down.
2. Swing the rail clamp of the device from below through the standard pro󹪝le rail.
3. Push the device in the direction of the standard pro󹪝le rail. You will hear the device click into
place.






Vertical Horizontal
Removing
1. Push down the device until it is released by the rail clamp.
2. Swing the device out of the standard pro󹪝le rail.
3. Lift the device up and o󹪜.
Installing/mounting
3.1Installation instructions SITRANS CC220
SITRANS CC220 and SITRANS MS200
28 Compact Operating Instructions, 10/2023 - DRAFT, A5E...-AA