Siemens SITRANS SCM IQ - Installing;Mounting; Installation Instructions SITRANS CC220; Mounting SITRANS CC220

Installing/mounting
3
3.1 Installation instructions SITRANS CC220
3.1.1 Mounting SITRANS CC220
Introduction
• Observe the safety notes in chapter Notes on use (Page19).
• The device is approved for indoor operation only.
• Install the device in cabinets, separate rooms or controlled areas. Only authorized personnel
may access the device using locks or similar measures.
• Observe the relevant DIN/VDE requirements or the applicable country-speci󹪝c regulations.
• Install the bluetooth antenna outside the cabinet.
• To install the mounting clamps and brackets, Siemens recommends you use 0.6Nm
tightening torque.
Before mounting the device
You have all needed anchors and screws available.
Material Bore diameter Fixing element
Concrete Select according to the speci󹪝‐
cation of the mounting ele‐
ments used
• Anchor, ∅ 6mm, 40mm long
• Screw, ∅ 4.5mm, 40mm long
Plasterboard,
(at least 13mm thick)
Toggle plug, ∅ 12 mm, 50 mm long
Metal,
(at least 2mm thick)
• Screw M4 × 15
• M4 nut
Procedure
1. Mount the device on DIN rails or wall.
Mounting positions and mounting types (Page25)
Mounting on DIN rails (Page28)
Vertical wall mounting (Page29)
2. Only mount by Siemens delivered bluetooth antenna.
3. Mount the bluetooth antenna outside the cabinet.
SITRANS CC220 and SITRANS MS200
Compact Operating Instructions, 10/2023 - DRAFT, A5E...-AA 23