Siemens SITRANS SCM IQ - Commissioning; Basic Safety Notes

Commissioning
5
5.1 Basic safety notes
WARNING
Commissioning and operation with pending error
If an error message appears, correct operation in the process is no longer guaranteed.
• Check the gravity of the error.
• Correct the error.
• If the error still exists:
– Take the device out of operation.
– Prevent renewed commissioning.
The same risk continues to apply when error messages are switched o󹪜 or disabled.
WARNING
Hot surfaces
Risk of burns resulting from hot surfaces.
• Take corresponding protective measures, for example by wearing protective gloves.
WARNING
Improper commissioning in hazardous areas
Device failure or risk of explosion in hazardous areas.
• Do not commission the device until it has been mounted completely and connected in
accordance with the information in Technical speci󹪝cations (Page63).
• Before commissioning take the e󹪜ect on other devices in the system into account.
SITRANS CC220 and SITRANS MS200
Compact Operating Instructions, 10/2023 - DRAFT, A5E...-AA 43