Siemens SITRANS SCM IQ - Installation Location Requirements; General Description

3.2.1.1 Installation location requirements
NOTICE
Aggressive atmospheres
Damage to device through penetration of aggressive vapors.
• Ensure that the device is suitable for the application.
NOTICE
Direct sunlight
Damage to device.
The device can overheat or materials become brittle due to UV exposure.
• Protect the device from direct sunlight.
• Make sure that the maximum permissible ambient temperature is not exceeded. Refer to
the information in Technical speci󹪝cations SITRANS MS200 (Page65).
3.2.2 General description
NOTICE
Wrong assembly
Wrong assembly can damage the asset or the SITRANS MS200.
• Carefully read the safety instructions before mounting.
SITRANS MS200 has an M8 female thread for the installation, see Dimension drawings
SITRANSMS200.
For thread M8:
• minimum screw-in depth 5,5mm
• maximum screw-in depth 13mm
• screw-in torque min. 18Nm and max. 20Nm
• screw-in material stainless steel
Use an anaerobic adhesive thread locker.
SITRANS MS200 can be mounted in various ways utilizing its threaded M8 hole. As examples
for mounting you can:
• directly mount SITRANS MS200 to an existing stud bolt
• use a short threaded bolt to mount SITRANS MS200 to a threaded hole
• use a clamp shell to mount SITRANS MS200 to a pipe
Installing/mounting
3.2Installation instructions SITRANS MS200
SITRANS CC220 and SITRANS MS200
36 Compact Operating Instructions, 10/2023 - DRAFT, A5E...-AA