Siemens SITRANS SCM IQ - Page 57

1. Stop anomaly detection models of the respective SITRANSMS200.
2. Reposition SITRANSMS200.
3. Make sure SITRANSMS200 is powered up.
4. Delete machine learning models based on old data from asset (if existing) by clicking on
"Sensor data modelling" > click on your sensor > "See details".
5. Train new anomaly detection model only based on new data.
Moving SITRANSMS200 to another machine or repositioning on the same machine (di󹪜erent
MindSphere asset)
Note
In this scenario SITRANSCC220 remains the same and MindSphere changes.
1. Stop anomaly detection models of the respective SITRANSMS200.
2. Reposition SITRANSMS200.
3. Make sure SITRANSMS200 is powered up.
4. Change assignment to MindSphere asset of SITRANS MS200 in SITRANS SCM IQ by clicking
on "Device con󹪝guration > > Con󹪝gure sensor".
5. Delete anomaly detection models based on old data from asset (if existing) by clicking on
"Sensor data modelling" > click on your sensor > "See details".
6. Train new anomaly detection model model only based on new data.
Connecting SITRANSMS200 to another SITRANSCC220 (no repositioning)
Note
In this scenario the physical asset and the MindSphere asset remain the same.
1. Make sure that selected SITRANSCC220 is connected in SITRANSSCMIQ.
2. Change assignment of SITRANSMS200 in SITRANSSCMIQ to another SITRANSCC220 by
clicking on "Device con󹪝guration > > Con󹪝gure sensor".
3. Reset SITRANSMS200.
AUTOHOTSPOT
Connecting SITRANSMS200 to another MindSphere asset (no repositioning)
Note
In this scenario the physical asset and the SITRANSCC220 remain the same.
Service and maintenance
6.3Maintenance and repair work for SITRANS MS200
SITRANS CC220 and SITRANS MS200
Compact Operating Instructions, 10/2023 - DRAFT, A5E...-AA 57