Siemens Synco 700 Series - Precontrol; Overview of Function Block; Configuration

138/232
Building Technologies Boiler Sequence Controller RMK770 CE1P3132en
HVAC Products 9 Precontrol 23.04.2009
9 Precontrol
9.1 Overview of function block
DC 0...10 V
Flow
Heating curve
close
Primary controller
DHW
3132S82
T
T
T
TRt
TFl
Precontrol
TFl Flow temperature
TRt Return temperature
9.2 Configuration
Function block “Primary controller“ must always be activated in the extra configuration.
The function block is activated by assigning an output to a terminal.
Main menu > Commissioning > Extra configuration > Primary controller > Outputs
Operating line Adjustable values / remarks
Mixing valve 3-pos
Mixing valve modulating
System pump
System pump B
Main menu > Commissioning > Extra configuration > Primary controller > Inputs
Operating line Adjustable values / remarks
Flow sensor
Return sensor
[System pump] overload
[System pump B] overload
Flow signal pump
Heat request modulating
Heating curve request 2-pos
DHW request 2-pos
Frost prot request 2-pos
Basic configuration
Extra configuration
Outputs
Inputs