Siemens Synco 700 Series - Assignment of Texts; Fault Handling

189/232
Building Technologies Boiler sequence controller RMK770 CE1P3132en
HVAC Products 11 Data acquisition 23.04.2009
11.3.7 Assignment of texts
Each meter can be assigned specific text. This text appears on the operating pages in
the form of menu text and datapoint text.
Main menu > Commissioning > Settings …
or
Main menu > Settings > Data acquisition > Meter 1
(or 2, 3 or 4)
Operating line Range Factory setting
Meter reading 1*
Max. 20 characters
Meter reading 1*
* Or meter reading 2, 3 or 4
11.3.8 Fault handling
Battery-powered and mechanical meters also continue to operate in the event of a
power failure. If power supply to the RMK770 controller fails, the pulses are not
counted.
When the
Extra configuration menu is quit, a restart is made. Pulses received between
last storage and restart (maximum 5 minutes) are not counted.
No. Text Effect
9401 No pulse signal meter 1
Meter input 1 receives no pulses from the
heat meter. Nonurgent message; must be
acknowledged
9402 No pulse signal meter 2
Meter input 2 receives no pulses from the
heat meter. Nonurgent message; must be
acknowledged
9403 No pulse signal meter 3
Meter input 3 receives no pulses from the
heat meter. Nonurgent message; must be
acknowledged
9404 No pulse signal meter 4
Meter input 4 receives no pulses from the
heat meter. Nonurgent message; must be
acknowledged
Settings
Fault status messages