Siemens Synco 700 Series - Increasing the Economy Setpoint; Room Temperature Setpoint Adjuster, Absolute

160/232
Building Technologies Boiler Sequence Controller RMK770 CE1P3132en
HVAC Products 10 Heating circuit control 23.04.2009
10.4.2 Increasing the Economy setpoint
The room temperature setpoint of Economy mode is increased depending on the
composite outside temperature. The increase is greater at low outside temperatures
and zero at high outside temperatures; the transitions are adjustable.
The function helps prevent peak loads when changing from Economy to Precomfort or
Comfort mode.
3133D04
TOeff
TRSetpt
TRSetptEco
TRSetptPreC
TRSetptCmf
–15°C
EndPt
–5°C
SrtPt
TRSetptEco+
Δ
TRSetptEco+
Δ /
TRSetptPreC+
Δ
EndPt End point of increase (here –15 °C)
SrtPt Start point of increase (here –5 °C)
Toeff Composite (effectively acting) outside temperature
TRSetpt Room temperature setpoint
TRSetptCmf Comfort setpoint
TRSetptEco Economy setpoint
TRSetptEco+
Δ Increased Economy setpoint
TRSetptPreC Precomfort setpoint
TRSetptPreC+
Δ Increased Precomfort setpoint
Main menu > Settings > Heating circuit > Optimizations/influences
Operating line Range Factory setting
Economy increase start point –15…50 °C –5 °C
Economy increase end point –50…–5 °C –15 °C
The
Inputs/setpoints menu shows the extent of Economy setpoint increase:
Main menu > Heating circuit > Inputs/setpoints
Operating line Adjustable values / display / remarks
Economy increase Inactive / Active
10.4.3 Room temperature setpoint adjuster, absolute
For preselection of the room temperature setpoints for Comfort and Precomfort mode, a
remote setpoint adjuster (e.g. BSG21.1) can be configured.
The 4 setpoints can be readjusted as shown in the following illustration.
The upper curve shows the difference between the remote setpoint adjuster’s setpoint
and the selected Comfort setpoint. This difference affects the other setpoints in different
ways. This is shown by the curves in the lower part of the diagram.
Settings
Display values