46/232
Building Technologies Boiler Sequence Controller RMK770 CE1P3132en
HVAC Products 3 Commissioning 23.04.2009
3.7 Completing commissioning
If the application is correct, the Commissioning menu can be quit as follows:
1.
Press the ESC button. The display shows a dialog box with the following information:
Caution!
Plant starts
ESC
OK
2. Confirm by pressing the OK knob. Then, the controller starts using the settings
made; the plant is started up, and the Main menu appears on the display.
Main menu
Commissioning…
Boiler sequence manager…
Boiler 1…
Boiler 2 …
3.8 Data backup
When commissioning is completed, the entire commissioning data set (configuration
and all settings) can be stored in the controller. If any time later, an unauthorized
person readjusts important values, this function can be used to restore the proper
controlled state after commissioning.
Main menu > Data backup
Operating line Remarks
Storage date
Display of the date on which the commis-
sioning data set was downloaded to the
controller’s memory
Storage year
Display of the year in which the commission-
ing date set was downloaded to the control-
ler’s memory
Main menu > Data backup
Operating line Remarks
Restore
Caution! New configuration
Save
Caution! Stored data will be overwritten.
3.9 Device information
On the Device information menu, information about the controller, such as the software
version, can be viewed.
Main menu > Device information > Controller
Operating line Remarks
Plant type Display of plant type
Plant type adapted
Display of an intervention made in the
programmed application (yes, no)
File name
Has a function only in connection with
ACS7… Display of file name of the applica-
tion currently loaded
Can be edited under Settings > Texts.
Device type RMK770-…
Software version Display of software version
Hardware version Display of hardware version
Display values
Setting
Display values
To Next Page
Loading...
