EasyManua.ls Logo

Siemens Synco 700 Series - Calendar Data (Holidays and Special Days)

Siemens Synco 700 Series
232 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
207/232
Building Technologies Boiler sequence controller RMK770 CE1P3132en
HVAC Products 14 Communication 23.04.2009
RM..
RM..
3131Z07
Slave
Device 2
Master
Device 1
Time of day
Time of day
Legend for all figures in this
chapter:
Signal transmitter
Signal receiver
Effects when communication is activated:
Fault status messages are always delivered via bus and can be further handled by
other Synco™ 700 devices
Fault status messages from other Synco™ 700 devices are shown on the display
under:
Main menu > Faults > Fault status message bus
Fault status messages from other Synco™ 700 devices can be delivered to a fault
relay
All fault status messages can be acknowledged from a remote location (e.g. from the
PC operator station or via the OCI700 service interface).
It can be selected whether fault status messages with self-holding may also be reset
from a remote location or whether self-holding must always be reset with the local
push-button.
14.2 Calendar data (holidays and special days)
The RMK770 controller has a calendar for the entry of holidays and special days. If
required, a calendar of another Synco™ 700 device can be used.
Optionally, other Synco™ 700 devices can use the RMK770 calendar.
This is made possible via the following communication settings:
Main menu > Commissioning > Communication > Room heating circuit
Operating line Range Factory setting
Holidays/special day operation Autonomous / Slave /
Master
Autonomous
Holidays/special day zone 1…31 1
The settings made are also displayed under:
Main menu > Device information > Communication > …
If a common holiday or special day program shall be used, holidays/special day opera-
tion must be defined as the master on one of the devices, and the other(s) is (are)
slave(s). Operation with the 4 internal calendars is analogous.
With master-slave operation, this setting is used to assign the zones. The slaves are
assigned the same holidays/special day zone as the master. It is possible the define
several zones with 1 master per zone.
Remote reset of fault
Communication
Holidays/special day
operation
Holidays/special day zone

Table of Contents

Related product manuals