Siemens Synco 700 Series - Primary Controller; Heating Circuit

222/232
Building Technologies Boiler Sequence Controller RMK770 CE1P3132en
HVAC Products 16 Addendum 23.04.2009
Main menu > Settings > Boiler 1 (or 2…6) > Fault settings
Datapoint name Factory setting
[Boiler x] boiler sensor error [Bx] boil sens err
[Boiler x] return sensor error [Bx] ret sens err
[Bx] flue gas temp sensor error [Bx] flue gas s err
[Bx] flue gas overtemperature [Bx] flue gas o’temp
[Bx burner] fault [Bx burner] fault
[Bx burner] no checkback signal [Bx bu] no ch’back sign
[Bx valve] no checkback signal [Bx va] no ch’back sign
[Bx pump] overload [Bx P] overload
[Bx pump] no flow [Bx P] no flow
[Bx pump B] overload [Bx P B] overload
[Bx pump B] no flow [Bx P B] no flow
[Boiler x pump] fault [Bx pump] fault
16.2.3 Primary controller
Main menu > Settings > Primary controller
Datapoint name Factory setting
Primary controller: Primary controller
Main menu > Settings > Primary controller > Fault settings
Datapoint name Factory setting
Prim controller error flow sensor Pri ctr err fl sens
Prim controller error return sensor Pri ctr err ret sens
[System pump] overload [SP] overload
[System pump B] overload [SP B] overload
[System pump] no flow [SP] no flow
[System pump B] no flow [SP B] no flow
[System pump] fault [SP] fault
16.2.4 Heating circuit
Main menu > Settings > Heating circuit
Datapoint name Factory setting
Heating circuit: Heating circuit
Time switch: Time switch
Main menu > Settings > Heating circuit
Datapoint name Factory setting
[HC 1] error flow sensor [HC 1] err flow sens
[HC 1] error return sensor [HC 1] err ret sens
[Heating circuit pump] overload [HCP] overload
[Heating circuit pump B] overload [HCP B] overload
[Heating circuit pump] no flow [HCP] no flow
[Heating circuit pump B] no flow [HCP B] no flow
[Heating circuit pump] fault [HCP] fault