Siemens Synco 700 Series - Holidays; Special Days

60/232
Building Technologies Boiler Sequence Controller RMK770 CE1P3132en
HVAC Products 5 General functions, fundamentals 23.04.2009
Entry Effect Diagram
Slave
The holidays / special day program in this
controller is not active.
The program acting is the external holidays /
special day program that has the same holi-
days / special day zone set. The external
holiday / special day program must be set as
the master holidays / special day program
Master
The holidays / special day program in this
controller is active.
The holidays / special day program also acts
on all other controllers where the holidays /
special day program is switched off (slave) and
which lie in the same holidays / special day
zone.
3140Z09
Main menu > Commissioning > Communication > Room heating circuit
Operating line Range Factory setting
Holidays/special day operation
Autonomous / Slave /
Master
Autonomous
Holidays/special day zone 1…31 1
For more detailed information about the setting regarding the communication of holi-
days / special days, refer to chapter 14 “Communication”.
5.2.2 Holidays
Holidays are periods of time
• during which the building is not occupied
• whose start and duration are known in advance
Examples:
• Works holidays in commercially used spaces and buildings
• School holidays in school buildings
• Public holidays
The operating mode to be used during the holiday period can be individually selected
for each heating circuit and each DHW heating facility. For the heating circuits, the
following operating modes can be selected:
Main menu > Heating circuit > Room operating mode
Operating line Range Factory setting
Room operating mode holidays
Economy /
Sustained mode
Economy
5.2.3 Special days
Special days are periods of time during which the building is used for special purposes
and whose start and duration are known in advance. These are especially public holi-
days.
The 7-day program can accommodate an additional 24-hour program (special day) as a
special day program. The setting is described in section 5.1 “Time switch”.
If the controller (master) is connected to other controllers (slaves) via communication, a
specific 7-day program can be entered as a special day on each of the controllers
(slaves). The time of the special day is a preselection made by the master and applies
to all controllers in the same holidays / special day zone.
Setting