Siemens Synco 700 Series - Heating Circuit Control; Overview of Function Block; Configuration

150/232
Building Technologies Boiler Sequence Controller RMK770 CE1P3132en
HVAC Products 10 Heating circuit control 23.04.2009
10 Heating circuit control
10.1 Overview of function block
close
Heating circuit
Timer function
Special day input
Holidays input
3133S101
T
T
TRtHCtr
TFlHCtr
HCtrPu
HCtrVlvMx
T
TR
HCtrPu_B
T
TO
HctrPu Heating circuit pump
HctrPu_B Heating circuit pump B
HCtrVlvMx Heating circuit mixing valve
TFlHCtr Flow temperature sensor
TO Outside sensor
TR Room temperature sensor
TRtHCtr Return temperature sensor
10.2 Configuration
Function block “Heating circuit” must always be activated in the extra configuration.
The function block is activated
• by assigning an output to a terminal, or
• by setting “Heating circuit = Active“
Main menu > Commissioning > Extra configuration > Heating circuit
Operating line Range Factory setting
Virtual heating circuit Inactive / Active Inactive
Heating circuit diagram
Basic configuration
Extra configuration