Refrigerated Centrifuge Sigma 8KS
Refrigerated Centrifuge Sigma 8KBS
Version 08/2012, Rev. 2.5 of 02/07/2018 • sb
Translation of the original operating manual, part no. 0702502
Inlet pressure (water cooling system) ......... 84
Input fuse ............................................. 14, 84
Inspection by the manufacturer .................. 80
Installation of a rotor .................................. 41
Installation of accessories .......................... 42
Installation of an angle rotor with a hermetic
lid ........................................................... 41
Installation of rotors and accessories ......... 41
Insufficiently greased load-bearing bolts .... 77
Intended use ................................................ 9
Interrupting a centrifugation run ................. 46
Interrupting a deceleration process ............ 46
Invert .......................................................... 59
IP code ...................................................... 84
K
Kinetic energy ...................................... 14, 84
L
Language ................................................... 59
Layout of the centrifuge.............................. 11
Layout plan .............................................. 125
Leaks ......................................................... 79
Lid cannot be opened ................................ 70
Lid error ..................................................... 72
Lid lock device ........................................... 26
Lid lock has not released ........................... 70
Lid seal sticks ............................................ 70
Lifting and carrying rotors ........................... 24
Limit "Delta T" ............................................ 56
Linear curves ............................................. 88
Loading a process ...................................... 53
Loading a program ..................................... 66
Lock ........................................................... 57
M
Mains plug ................................................. 15
Mains power switch off ............................... 70
Mains voltage ............................................. 21
Maintenance .............................................. 74
Malfunctions and error correction ............... 70
Manual mode ............................................. 46
Manufacturer .............................................. 84
Marking of rotors ........................................ 25
Marking of the unit ..................................... 18
Maximum speed for tubes .......................... 43
Measures in the event of hazards and
accidents ................................................ 27
Mechanical safety ...................................... 21
Menu Barcode ........................................... 62
Menu Curve ............................................... 61
Menu Help ................................................. 64
Menu Parameters ...................................... 54
Menu Processlibrary .................................. 53
Menu Setup ............................................... 58
Menu Standard .......................................... 47
Mode of operation ...................................... 16
Modification mode active ............................ 46
Motor error ................................................. 72
Motor shaft ................................................. 74
Multiple carrier ........................................... 43
N
Name plate .......................................... 14, 37
No indication on the display ....................... 70
No power in the mains supply .................... 70
Noise level ................................................. 84
Nominal voltage ......................................... 14
Notes on safety and hazards ....................... 9
O
Online download of forms .......................... 82
Open lid after run ....................................... 58
Opening the lid ........................................... 40
Operating conditions for water cooled
centrifuges .............................................. 39
Operating personnel .................................. 20
Operating voltage....................................... 37
Operational safety of accessories .............. 75
Option for the input and output of data ....... 60
Option: Barcode menu ............................... 62
Options for data input and output ............... 69
Overheating ............................................... 33
Overseas shipping ..................................... 28
P
Packaging .................................................. 29
Parameter error ......................................... 72
Parameters menu ...................................... 54
Pathogenic substances .................. 22, 74, 78
Plastic accessories, cleaning and care ....... 76
Potential hazard to the life and health ........ 19
Potentially hazardous situation................... 19
To Next Page
Loading...
