Sigma 8KBS - Installation of the Cover Holder

Refrigerated Centrifuge Sigma 8KS
Refrigerated Centrifuge Sigma 8KBS
5 Set-up and connection
36 / 131
Version 08/2012, Rev. 2.5 of 02/07/2018 • sb
Translation of the original operating manual, part no. 0702502
Pos: 107 /100 Sig ma/110 BA Ze ntrifugen Sig ma (Projekte)/8K S_8KBS_8KHB S/050 Aufstellu ng und Anschl uss/050-001 3 Montage des D eckelhalters - fl acher Deckel @ 46\mod_1 48153700866 4_68.docx @ 4616 75 @ 2 @ 1
5.3 Installation of the cover holder
The cover of the swing-out rotor 11805 with a windshield can be placed in
the lid of the centrifuge when loading or unloading the centrifuge. In
addition, it is possible to install a cover holder on the right side of the
centrifuge. The required accessories are included in the scope of supply:
1 Holder for the rotor
cover
2 Hexagon socket head
screw (M6x16)
Fig. 15: Cover holder accessories
Installation
There is a hole for the cover holder in the middle of the upper edge on the
right-hand side of the centrifuge.
• Insert the hexagon socket head screw through the hole of the cover
holder and fasten the cover holder to the hole on the right-hand side of
the centrifuge by way of the hexagon socket key (included in the scope
of supply).
3 Holder in the
centrifuge lid
4 External holder
Fig. 16: Storage options for the windshield cover
Pos: 108 /010 Uni versalmodule/ Seitenwechsel @ 0\mod_12 02116244312 _0.docx @ 105 @ @ 1