Sigma 8KBS - Condensate Drain

Refrigerated Centrifuge Sigma 8KS
Refrigerated Centrifuge Sigma 8KBS
5 Set-up and connection
38 / 131
Version 08/2012, Rev. 2.5 of 02/07/2018 • sb
Translation of the original operating manual, part no. 0702502
Pos: 116 /100 Sig ma/110 BA Ze ntrifugen Sig ma (Projekte)/8KS _8KBS_8KHBS/ 050 Aufstellung und Anschl uss/050-005 0 Kondensata blauf @ 29\mod _1405327408 547_68.doc x @ 199815 @ 2 @ 1

5.5 Condensate drain
The condensate drain is used to drain the condensate off that forms in the
rotor chamber during the centrifugation. It consists of a hose with a plastic
valve. This hose runs from the rotor chamber to a point on the left behind
the front door of the centrifuge.
WARNING
• Do not open the condensate drain unless the rotor is at a complete
standstill.
Draining the condensate off
• Unplug the mains power plug.
• Open the front door with the supplied square spanner (order no. 930
114).
• Connect the supplied hose connector and drain the condensate.
• Disconnect the hose connector by pressing the unlocking button.
NOTE
At the installation site, the condensate drain can be laid to the outside (see
figure).
1 Drain outside of the centrifuge
2 Hose (part no. 80415)
3 Hose connector (unblocks the
drain when connected)
4 Unlocking button
5 Plug (to be removed prior to the
installation)
6 Centrifuge door (front, left side)
7 Clamp
8 Quick coupling
9 Lock nut (fasten by hand)
10 Condensate – rotor chamber
Fig. 17 Laying the condensate drain to the outside
Pos: 117 /010 Uni versalmodul e/Seitenwechsel @ 0\mod_12 02116244312 _0.docx @ 105 @ @ 1