Refrigerated Centrifuge Sigma 8KS
Refrigerated Centrifuge Sigma 8KBS
Version 08/2012, Rev. 2.5 of 02/07/2018 • sb
Translation of the original operating manual, part no. 0702502
Deleting the stored barcodes: "deletebarcodes"
This command is used to delete all of the stored barcodes.
The "Barcode" menu will be updated.
This command will not be accepted unless the centrifuge is at a standstill.
Reading out the data of the last centrifugation run: "getlastrun"
The response to this command includes information concerning the
parameters and status of the last centrifugation run (for the exact format of
the data see chapter 11.6 - "Serial Control Interface Specification").
If barcodes have been stored, they will also be output as follows:
• Syntax data structure 001:
"Barcode;x;abc\r\n" (x = serial number starting at 1, abc = barcode)
• Syntax data structure 020:
"Barcode;Staff Member ID;abc\r\n" (abc = barcode)
The enquiry can be performed at any time (before, during, and after the
centrifugation run). Depending on the time of the enquiry, some of the
results may still be unknown.
Pos: 166 /010 Uni versalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 1 14 @ @ 1
Pos: 167 /100 Sig ma/100 BA Ze ntrifugen Sig ma (Standardmo dule)/060 Betrieb _Spincontrol L+S/Spincontrol S (Zent7)/0 60-0030-0020-0 090 Menü Hilfe @ 27\mod _1405320230870 _68.docx @ 19 3417 @ 4 @ 1
6.3.2.11 Help menu
The help function is symbolised by the " " symbol on the menu bar. It
provides a short description of the control elements of the selected option.
Activating and deactivating the help function
• Select the question mark on the menu bar and press the function knob.
• Quit the help function by selecting the question mark and by pressing
the function knob again.
Parameters can still be changed when the help function is activated.
Fig. 36: Menu "Help"
Pos: 168 /010 Uni versalmodule/ Seitenwechsel @ 0\mod_12 02116244312 _0.docx @ 105 @ @ 1
To Next Page
Loading...
