Sigma 8KBS - Page 131

Refrigerated Centrifuge Sigma 8KS
Refrigerated Centrifuge Sigma 8KBS
Index
Version 08/2012, Rev. 2.5 of 02/07/2018 • sb
131 / 131
Translation of the original operating manual, part no. 0702502
Speedometer error ..................................... 72
Spin-out from set speed ............................. 56
Standard menu .......................................... 47
Standards and regulations ......................... 10
Standstill cooling ........................................ 54
Standstill monitoring system ...................... 26
Start delay.................................................. 59
Starting a centrifugation run ....................... 46
Starting a process ...................................... 53
Sterilisation of the rotor chamber and
accessories ............................................ 78
Stopping of the centrifuge due to an
imbalance ............................................... 77
Storage and transport ................................ 28
Storage conditions ..................................... 28
Storage locations ....................................... 84
Stress-corrosion
see
corrosion ............................................. 76
Structural changes ..................................... 22
Supply voltage ........................................... 37
Supporting rings ......................................... 43
Switching the centrifuge off ........................ 69
Switching the centrifuge on ........................ 40
System ....................................................... 60
System check ............................................ 26
System error ........................................ 70, 72
T
Table of error codes ................................... 72
Table of rotors and accessories with a
different service life .................... 24, 44, 90
Tap connections (water cooling system) .... 84
Technical data ........................................... 84
Technical documentation ........................... 85
Temperature .............................................. 47
Temperature at the water inlet ................... 39
Temperature at water inlet ......................... 84
Temperature error ...................................... 72
Temperature inside the rotor chamber ....... 26
Temperature monitoring ............................. 56
Temperature monitoring system ................. 26
Temperature unit........................................ 59
Temperature value not reached ................. 70
Thermal stress ........................................... 74
Time fine .................................................... 59
Time range................................................. 84
Toxic substances ................................. 22, 74
Tubes ......................................................... 43
Type..................................................... 14, 84
Type of connection ..................................... 37
Type of the centrifuge .......................... 73, 80
U
Unblocking a function ................................. 57
Ungreased load- bearing bolts ................... 70
Useful volume
- volume that is stated for the tube .......... 43
User interface ............................................ 45
Using smaller blood bag systems ............... 44
UV radiation ......................................... 33, 74
V
Vessels ...................................................... 43
W
Warning signal ........................................... 60
Warranty and liability .................................... 9
Water circuit (draining) ............................... 28
Water connector ........................................ 39
Water cooling system ........................... 39, 84
Draining the water circuit ........................ 28
Water operating pressure ........................... 39
Wear .......................................................... 80
Weight ....................................................... 28
Work on the power supply system ............. 21
Y
Year of manufacture .................................. 14