Sigma 8KBS - Page 60

Refrigerated Centrifuge Sigma 8KS
Refrigerated Centrifuge Sigma 8KBS
6 Using the centrifuge
60 / 131
Version 08/2012, Rev. 2.5 of 02/07/2018 • sb
Translation of the original operating manual, part no. 0702502
System
Cycles
This field shows the number of cycles as well as the runtime of the rotor
and buckets that are used.
Info
This item provides information on the software versions that are used in this
centrifuge.
Sensor
The sensor mode is reserved for the service personnel.
NOTE
Values can neither be entered nor changed in the menus "Cycles", "Info",
and "Sensor".
Name
In this field, an identification will be assigned to the centrifuge.
• The letters and characters can be entered when the cursor flashes in
the text field. Turn the function knob in order to select a character and
press it to confirm the selection. Then, press the knob again in order to
enter the next character. Pressing the arrow button ← will delete the
last character. The maximum number of characters is 19.
• When the name is complete, select the option "Accept" and confirm it.
Buzzer (signal)
With this function, a warning sound signal can be selected for
• the end of a centrifugation run,
• an imbalance message,
• an error message.
The duration of the warning signal can be specified.
External
This function is only available if the centrifuge is equipped with the option
for the input and output of data (external signal, floating switch) (see
chapter 6.3.4 - "Options for data input and output").
Pos: 162 /010 Uni versalmodule/ Seitenwechsel @ 0\mod_12 02116244312 _0.docx @ 105 @ @ 1