26 |
Waypoints, routes & tracks | NSO-II Operator Manual
Waypoints, routes & tracks
Waypoints
A waypoint is a user generated mark positioned on a chart, on a radar image or on an
echosounder image. Each waypoint has an exact position with latitude and longitude
coordinates. A waypoint positioned on an echosounder image, will in addition to position
information have a depth value.
A waypoint is used to mark a position you later may want to return to. Two or more
waypoints can also be combined to create a route.
Positioning waypoints
Placing a waypoint at vessel position
You can position a waypoint at the vessel position from any panel by pressing and holding
the OP40 PLOT/MARK key.
Using the cursor to position
waypoints
On chart, echosounder and
StructureScan panels you can
place a waypoint on a selected
position by making a long
press on the screen to activate
the panel menu.
Edit waypoints
A selected waypoint can be deleted or edited on a chart panel from the menu, or from the
waypoint dialog.
You can quickly move a waypoint on a chart panel by tapping the desired new location on
the screen.
Using the edit waypoint dialog
This dialog is activated by tapping the waypoint and then
activating the menu, or pressing the rotary knob when the
waypoint is selected.
The dialog can also be activated from the Waypoint list.
See “Waypoints, route and tracks panels” on page 28.
Waypoint alarm settings
You can set an alarm radius for each individual waypoint
you create.
¼ Note: The waypoint radius alarm must be toggled ON in the alarm panel to activate an
alarm when your vessel comes within the dened radius.
Moving a waypoint by tapping the screen
1. Select the waypoint by tapping it
2. Activate the menu and select the move option
- The waypoint icon will change to indicate moving mode
3. Tap on the chart panel to select a new position
4. Conrm the new position by tapping the Finish moving panel button or by pressing the
OP40 rotary knob.
4
To Next Page
Loading...
Need help?
General
