86 |
Video | NSO-II Operator Manual
facing cameras used to back-down the vessel.
Video standard
NSO-II supports NTSC and PAL video. The two channels are set up individually. Check the
local video standard or the standard of your cameras.
FLIR camera control
If a FLIR camera is available on the Ethernet network, you can display the video and
control the camera from the NSO-II.
A video panel can be set up as a single panel, or as one of the panels on a multiple panel
page.
Establishing connection with the FLIR video camera
When a video panel is active, the NSO-II will automatically recognize a Flir camera if this is
available on the network.
¼ Note: When there is DHCP server present on the Ethernet network, FLIR camera will need
to be congured and set to have Static IP Address before the connection can be estab-
lished. For instructions on how to congure your specic FLIR camera model please refer
to FLIR documentation.
¼ Note: Only one FLIR camera can be connected to the Ethernet network at a time.
When you activate a video panel, the system will start searching the network for a FLIR
camera.
If the connection later is lost, this will be indicated by a panel key. Tap this key to re-
establish the connection.
When the connection is established the menu will change to include access to FLIR
camera control.
To Next Page
Loading...
Need help?
General
