9
Before Use
4. Safety Information
Plug the power cord into a properly grounded outlet which is close enough and accessible easily from the device.
Do not use or store the device in a wet or humid environment.
Injuries
-
This device uses laser technologies. When you control, alter, or execute procedures not specified in this
manual, you may be exposed to hazardous radiations.
This device uses a method to heat the printing media, so gas may be emitted from papers due to heating.
To prevent emission of the harmful gas, read and understand the section regarding the details on the
printing media in the operating guideline.
-
Follow the below instructions to prevent physical injuries or device damage when moving the device.
Press the power switch to turn off the power and unplug the power cord.
Unplug all cords and cables from the MFP before moving the MFP.
Do not try to lift optional tray and MFP together; separate MFP from the optional tray to move MFP.
When lifting the optional tray, use the handle located on both sides of the tray.
Use the provided power cord only or use replacement parts approved by the manufacturer only.
-
Do not twist or bend the power cord; do not step on it nor place a heavy weight on top of the cord. Be
careful not to damage the surface of power cord; be careful not to apply excessive force on the cord.
Do not make the power cord jammed into or between objects such as furniture or walls.
Misusing the power cord could result in fire or electrical shock. Check the power cord regularly.
Unplug the power cord from the outlet first for inspection.
Please consult a licensed electrician for services or repairs not stated in this user manual.
Surface Heat
-
The inside of the device may become very hot. Do not touch any heated parts before it is cooled down to
avoid any injuries due to the heated parts.
Electrical Shock
-
When accessing the system board, or installing hardware or optional memory devices, turn off the power
of the MFP and unplug the power cord from the outlet before proceeding your work. If the device is
connected to any other devices, turn off the power for other devices as well and disconnect the cables
from the MFP.
-
This device has been designed, tested, and approved to meet strict safety requirements of international
safety standards. Safety features of some parts may be unclear or unknown.
The manufacturer shall not be responsible for use of any other replacement parts.
-
Disconnect the power cord and all the cables connected to the MFP to prevent any electrical shock when
cleaning the outer surface fo the device.
To Next Page
