1-9
Preparation for using MFP
1
-
In power-saving mode, TX of document saved in memory, fax RX, print job RX from other computers are
available.
- In the following conditions, MFP will not enter the power-saving mode.
Scanning documents
Printing copies or faxes
Printing documents
Printing errors such as paper jams or low toner
Transmitting faxes
- For the following cases, the device automatically exits power-saving mode.
Receiving faxes
Receiving print job from computer
Setting document on ARDF flatbed
Pressing buttons or LCD control panel
To Next Page
