SKF 40PGA - Page 49

- 49 -
16642
Version 02
EN
15. Appendices
EN
15. Appendices
6.1.2 Setting the maximum
pressurisation time
Set the system's maximum pressurisation
time to match the minimum time required
for increasing the entire system's pressure to
the pressure switch acknowledgment level.
Press the function button until indicator 2
starts flashing rapidly (approximately 10
seconds).
Now the maximum pressurisation time can
be set.
Indicator P will flash several times. The
number of flashes corresponds to the cur-
rent maximum pressurisation time setting.
See the following table.
To increase the maximum pressurisation
time setting by one increment (see the ta-
ble), press the function button. When the
highest setting is reached, the setting cycle
starts from the beginning. To exit the setting
mode and save the changes in the circuit
board memory, hold the function button un-
til all three indicators light up (approximately
5 seconds).
Table 9. Lubrication cycle settings
Flashes
Maximum pressurisa-
tion time (min)
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
10 10
11 15
12 20