SKF FL15 - Commissioning and Daily Start-Up; Cleaning

FMON10JEN 07.04.2017 Rev. 10J
13 (13)
 All components used must be suitable for use in:
– the system’s maximum operating pressure, and
– the system’s minimum and maximum ambient temperature range.
 No parts of the centralised lubrication system may be subjected to twisting, shearing, or bending.
 Before using any parts, check them for contamination; clean if necessary.
 Lubricant lines should be primed with lubricant prior to installation. This makes it easier to bleed the
system of air afterwards.
 Observe the specified tightening torques. Use a calibrated torque wrench.
 When working with heavy parts, use suitable lifting tools.
 Avoid mixing up dismantled parts or assembling parts in the wrong order by marking the parts accord-
ingly.
Commissioning and daily start-up
Ensure that:
 All safety devices are completely installed and work properly.
 All connections are correctly connected.
 All parts have been correctly installed.
 All warning labels on the machine are complete, highly visible and undamaged.
 Replace illegible or missing warning labels without delay.
Cleaning
 There is a risk of fire and explosion when using flammable cleaning agents. Use only non-flammable
cleaning agents suitable for the purpose.
 Do not use aggressive cleaning agents.
 Do not clean using a steam jet or pressure washer, as these may damage electrical components.
Observe the IP protection class.
 Cleaning work on energised components may be carried out by electrical specialists only.
 Mark damp areas accordingly.