SKF FL15 - SKF Flowline Monitor FL50; SKF Flowline Monitor FL100

FMON10JEN 07.04.2017 Rev. 10J
19 (19)
SKF Flowline monitor FL50
The SKF Flowline monitor FL50 is designed for 15 - 50 l/min flow range. FL50 monitor is comprised of a con-
trol unit, one flow meter connected to the control unit and free flow tube. (fig. 3).
Figure 3 SKF Flowline monitor FL50 design
SKF Flowline monitor FL100
The SKF Flowline monitor FL100 is designed for 50 - 100 l/min flow range. FL100 monitor is comprised of a
control unit and two flow meter connected to the control unit ( fig. 4). There are two flow meters connected
in parallel and sum flow is shown in the display.

The active right LEDs display the status of the sum flow of two flowmeters.
You could adjust the sum flow from both flow valve.
Sensor´s left LED´s are not ON, only sensor´s right LED´s are ON.
The set alarm limits and the nominal flow are set for the sum flow.
Figure 4 SKF Flowline monitor FL100 design
.