FMON10JEN 07.04.2017 Rev. 10J
15 (15)
5 Delivery, returns and storage
Delivery
After receipt of the shipment, check the shipment for transport damage and completeness by comparing it to
the shipping documents. Immediately report any damage suffered in transport to the forwarding agent. Keep
the packaging material until any discrepancies are resolved. During in-house transport, ensure safe handling.
Returns
Clean all parts and pack them properly (i.e. following the regulations of the recipient country) before returning
them. Protect the product against mechanical stress (knocks, impacts). Land, sea or air transport can be used
for returns. Mark returns on the packaging as follows.
Storage
The products must be stored as follows:
Store in a closed, dry, dust- and vibration- free place.
Make sure there are no corrosive, aggressive materials at the place of storage (e. g. UV rays, ozone).
Protect against pests and animals (insects, rodents, etc.).
Can be stored in original product packaging.
Shield the product against heat and cold.
in case of high temperature fluctuations or high humidity, take adequate measures (e. g. heater) to
prevent condensation.
The product’s acceptable storage temperature range is the same as its operating temperature (see Tech-
nical data).
Before using the products, inspect them for damage sustained in storage. This applies to
parts made of plastic and rubber (embrittlement) as well as components primed with lubricant
(ageing) in particular.
To Next Page
Loading...
