SKF FL15 - 16 Cleaning; Cleaning Agents; Exterior Cleaning; Interior Cleaning

FMON10JEN 07.04.2017 Rev. 10J
58 (58)
16 Cleaning
WARNING
CAUTION! Conduct cleaning only on depressurised products that have been disconnected
from the power supply. Do not touch cables or electrical components with wet or damp
hands.
Use steam-jet cleaners or pressure washers only in accordance with the IP protection class
of the pump. Otherwise electrical components may be damaged.
Follow the operator’s standard operating procedures and instructions concerning cleaning,
cleaning agents, suitable tools and personal protective equipment.
Cleaning agents
Use only cleaning agents compatible with the material. For further information, see Chapter 4.14: Material
compatibility.
Thoroughly remove cleaning agent residues from the product and rinse with clear water.
Exterior cleaning
• Mark and secure wet areas.
• Keep unauthorized persons away.
• Clean all outer surfaces thoroughly with a damp cloth
. Interior cleaning
Interior cleaning is not usually required. However, if incorrect or contaminated lubricant has been used, the
product must be cleaned on the inside. To do so, contact the SKF Customer Service for further instructions.