1. Safety instructions
peratures (e.g., altered flow properties
of the lubricant). Maintenance and repair
work should therefore preferably be per-
formed at room temperature.
○ Prior to performing work, the product
and the machine in which the product
will be integrated must be de-energized,
depressurized, and secured against un-
authorized activation.
○ Take appropriate measures to ensure
that moving, detached parts are im-
mobilized during the work and that no
limbs can be pinched by unintended
movements.
○ Assemble the product only outside the
operating range of moving parts, at an
adequate distance from sources of heat
or cold. Other units of the machine, the
vehicle must not be damaged or impaired
in their function by the installation.
○ Dry any wet, slippery surfaces or cover
appropriately.
○ Cover hot or cold surfaces appropriately.
○ Work on electrical components may be
performed only by qualified electricians.
Note possible waiting times for discharge.
○ Do not touch cables or electrical compo-
nents with wet or moist hands.
○ Drill required holes only on non-critical,
non-load-bearing parts. Use existing
boreholes. Do not damage lines or cables
when drilling.
○
Observe any possible wearing spots. Pro-
tect components appropriately.
○ All components used must be designed
for:
- The maximum operating pressure
- The maximum/minimum ambient
temperature.
○ No parts may be subjected to torsion,
shear, or bending.
○ Check parts for contamination before use
and clean if necessary.
○ Lubrication piping should be filled with
lubricant prior to assembly. This simpli-
fies subsequent venting of the system.
○ Adhere to the specified torques. Use
a calibrated torque wrench when
tightening.
○ Avoid mixing up/incorrectly assembling
disassembled parts. Label parts.
1
- 13 -
951-230-008-EN
Version 04
ENEN
To Next Page
Loading...
Need help?
General
