Section 04 ENGINE
Subsection 04 (DISASSEMBLY/ASSEMBLY)
04-04-4 MMR2000_119_04_04A.FM
TOP END INSTALLATION
Install cylinder head gasket no. 15 and check that
both locating pins no. 16 are in place, as shown in
the next photo.
1. Cylinder head gasket
2. Locating pin
Check push rods no. 12 on both ends for wear.
Check also push rods for straightness.
Install push rod ends into lifters no. 17.
Reinstall cylinder head.
CAUTION: Ensure that push rods are properly
inserted into push rod guides and firmly seated
in the lifters.
Secure cylinder head with screws.
Reinstall cylinder head cover.
1
A31C2BA
2
To Next Page
Loading...
