Section 04 ENGINE
Subsection 04 (DISASSEMBLY/ASSEMBLY)
MMR2000_119_04_04A.FM 04-04-7
To reinstall bearings, reverse housing and use
same tools as for bearings removal, as shown in
the next photo.
TO INSTALL BEARING
Governor System
Detach governor spring (black), throttle return
spring and governor rod from governor arm. See
next photo.
1. Governor spring (black)
2. Throttle return spring
3. Governor rod
4. Governor arm
Loosen governor arm screw then remove gover-
nor arm.
From inside crankcase, rotate governor arm shaft
no. 14 then pull out governor slider no. 15 and
washer no. 16.
1. Rotate governor arm shaft
2. Remove governor slider with washer (not shown)
Using a small flat screwdriver, remove clip no. 17
from governor weight holder no. 18.
GOVERNOR ASS‘Y HAS BEEN REMOVED TO SHOW CLIP
1. Clip
2. Governor weight holder
Pull out governor weight holder and washer no. 19.
Remove pins no. 20 from governor weights no. 21
then remove governor weights.
A31C2GA
A31C2HA
123
4
A31C2IA
12
A31C2JA
1 2
To Next Page
Loading...
Need help?
General
