188
SJ1044 TH, SJ1044 THS, SJ1056 TH, SJ1056 THS, SJ1256 THS
230790ABA
Section 5 – Procedures Non-Routine Maintenance
18. Support the end of the carrier assembly and
remove the lower support bracket. After removing
it, lower the carrier carefully.
M62328AA
Figure 151
19. Pull the cable track out through the front access
hole above the carrier assembly. Guide it as it
is removed. Have an assistant push the hoses
towards the front from the side access hole.
M62305AA
Figure 152
If replacing a hydraulic hose inside the cable track:
▪
With the cable track removed, thread the hose
through it before installing. Make sure the new
hose is marked in the same manner as the one
removed.
If replacing the cable track itself:
▪
Remove the mounting bracket from the old cable
track and install it on the new one. Make sure the
bracket is straight before tightening the screws.
M62313AA
Figure 153
If removing the Carrier Assembly from the boom,
continue to “Carrier Assembly Replacement” on page
192.
To Next Page
Loading...
