151
Section 5 – Procedures Skycoded Module
5.4-9 Language Setting Procedure
The Skycoded display panel shows the operator
the status of the machine in real time. If the operator
raises the platform, the Skycoded display will show
“151:LIFTING!” These messages and associated codes
can be found in the Help Messages and Fault Codes
table. These messages can be shown in different
languages according to the user preference.
Change the language setting
1. Make sure the display is on the home page. If not,
push and pull the emergency stop button on the
base to cycle the power on your machine.
2. Press and hold the button for 3 to 4 seconds.
3. The display will show the language selection.
4. Press or to change the language.
5. Wait 3 to 4 seconds. The display will automatically
go back to the home page with the new language.
To Next Page
Loading...
