14 Decommissioning the Product
SMA Solar Technology AG
Operating manualEVC22-3AC-20-BE-en-10100
14 Decommissioning the Product
To decommission the charging station completely at the end of its service life, proceed as described
in this section.
CAUTION
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or
mounted.
• Transport and lift the product carefully. Take the weight of the product into account.
• Wear suitable personal protective equipment for all work on the product.
Procedure:
1. Disconnect the charging station from voltage sources (see Section9, page81).
2. Insert a screwdriver into the openings on the terminal blocks and remove the AC cable.
3. If the multifunction relay is used, remove the connection cable from the charging station.
4. If other cables (e.g., network cables or signal cables) are connected, remove them from the
charging station.
5. Close the charging station cover.
6. Unscrew the two screws that attach the charging station to the mounting bracket using a
screwdriver (TX25).
7. Lift the charging station up and off the mounting bracket.
8. If the charging station is to be stored or shipped in packaging, pack the charging station. Use
the original packaging or packaging that is suitable for the weight and dimensions of the
charging station.
To Next Page
Loading...
