SMA eCharger - Starting the Charging Process Via Authorization; Authorizing the Charging Process Via RFID Card

8 Operation
SMA Solar Technology AG
Operating manual EVC22-3AC-20-BE-en-10 77
8.13.4 Starting the charging process via authorization
8.13.4.1 Authorizing the charging process via RFID card
Requirement:
☐ The charging station is ready for operation and the green LED indicator is flashing (see
Section4.6, page27).
☐ The RFID card has been taught (see Section8.13.3.2, page76).
☐ Charging approval is activated (see Section8.13.3.1, page76)
Procedure:
1. Connect the charging cable to the vehicle.
2. Connect the charging cable to the charging station.
Note: At low temperatures (-25°C), more force is
needed to plug in the type 2 connector.
☑ The charging cable is locked.
☑ The yellow LED lights up. The charging station is locked.