SMA eCharger - Direct Connection Via Wi-Fi; Connection Options for Wi-Fi Direct Connection; Access Information for Direct Wi-Fi Connection; Establishing a Direct Wi-Fi Connection with WPS

8 Operation
SMA Solar Technology AG
Operating manual EVC22-3AC-20-BE-en-10 67
8.1.3 Direct connection via Wi-Fi
8.1.3.1 Connection options for Wi-Fi direct connection
You have several options to connect the product to a smart device. The procedure can be different
depending on the devices. If the procedures described do not apply to your end device, establish
the direct connection via Wi-Fi as described in the manual of your end device.
The following connection options ar available:
• Direct Wi-Fi connection with 360° app Establishing a direct Wi-Fi connection with the 360°
app
• Direct Wi-Fi connection with WPS Establishing a direct Wi-Fi connection with WPS
• Direct Wi-Fi connection with Wi-Fi network search (see Section8.1.3.4, page68)
8.1.3.2 Access information for direct Wi-Fi connection
Communication disturbances in the local network
The IP address range 192.168.12.0 to 192.168.12.255 is occupied for communication
amongst SMA products and for direct access to SMA products.
Communication problems might occur if this IP address range is used in the local network.
• Do not use the IP address range 192.168.12.0 to 192.168.12.255 in the local network.
Access information for the direct WiFi connection can be found below:
• SSID: SMA[serial number] (e.g. SMA0123456789)
• Device-specific Wi-Fi password: WPA2-PSK (see type label of the product)
• Default access address: https://smalogin.net or https://192.168.12.3
8.1.3.3 Establishing a direct Wi-Fi connection with WPS
Requirements:
☐ A smart device with WPS function must be available.
Procedure:
1. Activate the WPS Function on the charging station. To do so, tap on the enclosure lid of the
product twice.
☑ The blue LED flashes quickly for about two minutes. The WPS function is active during this
time.
2. Enable the WPS function on your smart device.
3. Open the web browser of your smart device and enter www.smalogin.net in the address bar.
☑ When you connect to the user interface for the first time, the welcome page opens. The
Commissioning Assistant for configuring the product can be started via the welcome page.
☑ The login page of the user interface opens if the product has already been configured.
Also see:
• Access information for direct Wi-Fi connection⇒page67