SMART LightRaise 60wi - Page 28

C H A P T E R 3
Using your interactive projector
20 smarttech.com/kb/170295
Setting Use Notes
Wall Color (displays the
color’s numeric value)
Adjusts projector brightness and
color temperature based on these
wall colors:
Color 1:Blackboard
Color 2: Blue
Color 3: Light Green
Color 4: Pink
Color 5: Light Yellow
The default is Blackboard.
N O T E
This is equivalent to a
Whiteboard.
Keystone Adjusts image keystone distortions
caused by movement of the
projector.
The default is 0. The keystone
can be adjusted from -15 to 15.
I M P O R T A N T
Use this setting only after you
make all physical image
alignment adjustments to
straighten the vertical lines of
the image.
Brightness Adjusts projector brightness from 0
to 100.
The default is 50.
Contrast Adjusts the difference between the
lightest and darkest parts
of the image from 0 to 100.
The default is 50.
Saturation Adjusts the image from black and
white to saturated color from 0 to
100.
The default is 50.
Sharpness Adjusts projected image sharpness
from 0 to 31.
The default is 16.
Tint Adjusts the image color balance of
red and green from 0 to 100.
The default is 50.
Frequency Adjusts the display data frequency
of the projected image from -5 to 5
to match the frequency of your
computer’s graphics card.
The default is 0.
This setting applies to VGA
inputs only.
Tracking Synchronizes your projector’s
display timing with your computer’s
graphics card from 0 to 63.
This setting applies to VGA
inputs only.