SMART LightRaise 60wi - Page 29

C H A P T E R 3
Using your interactive projector
21 smarttech.com/kb/170295
Setting Use Notes
H-Position Moves the horizontal position of the
source video left or right from 0 to
100 (relative to the projected
image).
The default is 50.
This setting applies to VGA
inputs only and is useful in
situations where the source
video is cut off.
I M P O R T A N T
l
Do not adjust this setting
unless advised to by
SMARTSupport.
l
Adjust this setting only
after you make all
physical image
adjustments.
V-Position Moves the vertical position of the
source video up or down from -5 to
5 (relative to the projected image).
The default is 0.
This setting applies to VGA
inputs only and is useful in
situations where the source
video is cut off.
I M P O R T A N T
l
Do not adjust this setting
unless advised to by
SMARTSupport.
l
Adjust this setting only
after you make all
physical image
adjustments.
White Peaking Adjusts the image color brightness
while providing more vibrant colors,
in increments from 0 to 10.
The default is 10.
A value closer to 0 creates a
natural image and a value closer
to 10 creates an enhanced
brightness.
Degamma Adjusts the color performance of
the display from 1 to 2 or from 0 to 3
depending on the display mode
selected.
The default varies depending on
the display mode.
Color Adjustment Opens a sub-menu where you can
adjust the projector’s Red, Green,
Blue, Cyan, Magenta and Yellow
colors from 0 to 100.
Each color has a default value of
100.
Color settings are saved to the
User display mode.