C H A P T E R 3
Using your interactive projector
27 smarttech.com/kb/170295
Setting Use Notes
Default Opens the Default sub-menu
where you can reset projector
settings to their default values.
If you press ENTER on the
remote control, all projector
settings reset to their defaults,
reversing any menu changes you
made. This action is irreversible.
Don’t adjust this setting unless
you want to reset all of the
applied settings, or unless you’re
advised to by a SMARTSupport
specialist
(smarttech.com/contactsupport).
Network menu
Network and VGA1 out Activates the projector’s VGA1out
and network features.
The default is Off.
Status Displays the current network status
(Connected, Disconnected or
Off).
DHCP Displays the status of the
network’s Dynamic Host Control
Protocol (DHCP) as On or Off.
The default is Off.
Password Reminder E-mails the network password to
the
e-mail recipient.
See Remotely managing your
interactive projector on page 73
to set up a destination e-mail
address.
IP Address Displays the projector’s current IP
address in values between 0.0.0.0
and 255.255.255.255.
To change the projector’s IP
address, use the RS-232
connector (see Network controls
on page 88) or use a DHCP
server to assign a dynamic IP
address, and then set a static IP
address using the network
remote management feature (see
Remotely managing your
interactive projector on page 73).
Subnet Mask Displays the projector’s subnet
mask number in values between
0.0.0.0 and 255.255.255.255.
Gateway Displays the projector’s default
network gateway in values
between 0.0.0.0 and
255.255.255.255.
To Next Page
Loading...
