C H A P T E R 9
Connecting your room control system to your interactive projector
90 smarttech.com/kb/170295
Command Response
get startupscreen startupscreen=[current startup screen setting]
get resolution resolution=[current input resolution]
get language language=[current language setting]
get groupname groupname=[current projector group name]
get projectorname projectorname=[current projector name]
get locationinfo locationinfo=[current projector location]
get contactinfo contactinfo=[current support contact information]
get modelnum modelnum=[current model number]
get serialnum serialnum=[serial number]
get emergencyalertmsg emergencyalertmsg=[current emergency alert message]
get emergencyalert emergencyalert=[current emergency alert setting]
These commands inform you of the current system settings. These commands are available even
when the projector is in Standby mode.
Command Response
get lamphrs lamphrs=[current lamp hours of operation]
get syshrs syshrs=[current projector hours of operation]
get fwvertouch fwvertouch=[current touch detection module firmware]
get fwverddp fwverddp=[current projector firmware version]
get fwvernet fwvernet=[current network firmware version]
get fwvermpu fwvermpu=[current processor firmware version]
get signaldetected signaldetected=[true or false]
These commands control the current system settings. These commands are unavailable when the
projector is in Standby mode. See Value-based command methods on page 82 for setting absolute
and adjustment commands.
Command Command target range Response
set cppower [target] =on
=off
cppower=[target]
set autosignal [target] =on
=off
autosignal=[target]
set lampreminder [target] =on
=off
lampreminder=[target]
To Next Page
Loading...
