C H A P T E R 9
Connecting your room control system to your interactive projector
91 smarttech.com/kb/170295
Command Command target range Response
set highbrightness [target] =on
=off
highbrightness=[target]
set autopoweroff [value] =0 to =240 autopoweroff=[value]
set zoom [value] =0 to =30 zoom=[value]
set projectorid [value] =0 to =99 projectorid=[value]
set hposition [value] =0 to =100 hposition=[value]
set vposition [value] =-5 to =5 vposition=[value]
set aspectratio [target] =fill
=match
=16:9
aspectratio=[target]
set projectionmode [target] =front
=ceiling
=rear
=rear ceiling
projectionmode=[target]
set startupscreen [target] =smart
=usercapture
=preview
startupscreen=[target]
To Next Page
Loading...
