Page 12
501 SE Columbia Shores Boulevard, Suite 500, Vancouver, Washington 98661, USA l +1 360 859 1780
SmartRG Inc. Propriety and Condential. All Rights Reserved. Copyright © 2014 smartrg.com
NOTE: The gateway’s UI can be accessed via the WAN connection by entering the WAN IP address in your browser’s address bar
and entering the default username and password: support/support. WAN HTTP access control MUST be enabled to access the
gateway’s UI via the WAN connection. Reference section on Management Access Control for details.
If your SmartRG gateway is congured for “bridge mode” (modem) operation, your PC will NOT be able to acquire an address via
CPE’s DHCP. Instead, manually congure your PC’s interface with an IP address on the default network (e.g. 192.168.1.100).
The balance of this guide is dedicated to a sequential walk-through of the user interface of your gateway. Here you will nd a visual refer-
ence of each screen along with a Description for each of the parameters displayed. Where applicable, a range of valid values is outlined
along with an overview narrative of each screen.
For in depth ”how-to” information for specic scenarios, please take advantage of the knowledge base found at our support web site. Ac-
cess to this site is restricted to SmartRG customers and partners. Do not attempt to share links to this site with your subscribers.
To Next Page
Loading...
